Tips for intsalling pallet storage racks
Properly trained personnel are required for the installation of pallet storage racks because if racks are not assembled properly they not only lead to poor performance but can also pose hazard to the safety of those who handle them. Training becomes all the more important in case of installing a drive-in-rack job, multi-level pick system, push back rack, pallet flow rack or a roller rack system. All of these systems require a different level of training.
Some important points to be taken care of include:
* The rack structure be installed in a plumb level and square condition.
* Nut and bolt connections should be tightened to a snug and secure condition.
* Safety locks use fully engaged through the beam connectors and upright column connector holes to prevent accidental dislodgement of the load beams.
* Every foot plate of each rack frame must be anchored to an adequate concrete floor.
* Avoid installing racks outdoors unless specifically designed by Material Flow or someone like them.
* Be careful when intermingling new and existing parts because even components made by the same company can vary in design.
* Be sure to install capacity plates signs.
* Allow for adequate aisle spacing.
* Use only pallets of the best quality. Avoid using broken boards, portruding nails and the like as they can cause palletized loads to fall from racks.
* Regular inspection of your rack system is a must which involves checking that the anchor nuts are tight and other nuts and bolts are secure or whether safety locks and clips are bent or missing and so on.
Subscribe to the comments for this post